Setting The Powered Zone 2 - Onkyo SR705 - TX AV Receiver Instruction Manual

TX-SR705_En.book Page 100 Monday, May 28, 2007 2:13 PM
Zone 2—Continued

Setting the Powered Zone 2

To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "7. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
ENTER
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
ENTER
3
Use the Up and Down [ ]/[ ]
buttons to select "2. Zone2," and
then press [ENTER].
The Zone2 menu appears.
ENTER
7–2. Zone2
Powered Zone2
ENTER
4
Use the Left and Right [
buttons to select:
Not Act: ZONE 2 SPEAKERS termi-
Act: ZONE 2 SPEAKERS termi-
When Zone 2 is activated and turned on
(see below), the speakers connected to
the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURR BACK SPEAK-
ERS terminals do not (when Zone 2 is
activated but not used, the surround
back speakers work as normal).
100
]/[ ]
Not Act
]/[ ]
nals deactivated.
nals activated.
5
Press the [SETUP] button.
The setup menu closes.
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.