Lock Setup; Digital Input Signal Formats - Onkyo TX-SR604 Instruction Manual

Advanced Setup—Continued

Lock Setup

1 Press the [RECEIVER] button fol-
RECEIVER lowed by the [SETUP] button.
The main menu appears onscreen.
SETUP
2
Use the Up and Down [ ]/[ ]
buttons to select "9. Lock Setup,"
and then press [ENTER].
9.Lock Setup
------------------------
a.Lock
With this preference, you can protect your settings by
locking the setup menus.
When the setup menus are locked, you cannot change
any setting.
Locked: Setup menus locked.
Unlocked: Setup menus not locked.
:Unlocked

Digital Input Signal Formats

The digital input signal formats are available only for the
input sources that you have assigned a digital input jack;
otherwise you will see "Analog" indicated on the screen
(see page 44).
Normally, the AV receiver detects the signal format auto-
matically. However, if you experience either of the fol-
lowing issues when playing PCM or DTS material, you
can manually set the signal format to PCM or DTS:
• If the beginnings of tracks from a PCM source are cut
off, try setting the format to PCM.
• If noise is produced when fast forwarding or reversing
a DTS CD, try setting the format to DTS.
DIGITAL INPUT
1 Press and hold the AV receiver's [DIGI-
TAL INPUT] button for about 3 seconds.
2 While "Auto" is displayed (about 3 sec-
onds), press the [DIGITAL INPUT] button
again to select: PCM, DTS, or Auto.
DTS or PCM: The DTS or PCM indicator,
depending on which format you have set, flashes,
and only signals in that format are output. Digital
signals in other formats are ignored.
Auto (default): The format is detected automat-
ically. If no digital input signal is present, the cor-
responding analog input is used instead.
77