Changing The Input Display; Minimum Speaker Impedance (Not North American Models) - Onkyo TX-SR604 Instruction Manual

First Time Setup—Continued

Changing the Input Display

If you connect an -capable Onkyo MiniDisc
recorder, CD recorder, or next generation HDD-compat-
ible component to the TAPE IN/OUT or VIDEO 3 IN
jacks, for to work properly, you must change this
setting.
This setting can only be changed on the AV receiver.
1, 2
iPod photo: If you're using an iPod photo with the
DS-A1 Remote Interactive Dock, connect the DS-A1 to
the VIDEO 3 IN jacks.
1
Press the [TAPE] or [VIDEO 3]
TAPE
input selector button so that
"TAPE" or "VIDEO 3" appears on
the display.
VIDEO 3
2
Press and hold down the [TAPE]
TAPE
or [VIDEO 3] input selector but-
ton (about 3 seconds) to change
the setting.
Repeat this step to select MD, CDR, or
VIDEO 3
HDD.
For the TAPE input selector, the setting
changes in this order:
→
TAPE
For the VIDEO 3 input selector, the set-
ting changes in this order:
VIDEO 3
Note:
HDD can be selected for the TAPE input selector or
VIDEO 3 input selector, but not both at the same time.
1, 2
→ →
MD CDR HDD
↔
HDD
Minimum Speaker Impedance (not
North American models)
If you change this setting, you must run the automatic
speaker setup again (see page 38).
If the impedance of any speaker is 4 ohms or more but
less than 6, set the minimum speaker impedance to 4
ohms.
Note:
Before you change this setting, turn down the volume.
1 Press the [RECEIVER] button,
RECEIVER
followed by the [SETUP] button.
The main menu appears onscreen.
SETUP
2
Use the Up and Down [
buttons to select "8. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
8.Hardware Setup
------------------------
a.SP Impedance :6ohms
b.PoweredZone2:NotAct
c.TV Format
d.AM Freq. Step: 9kHz
e.Remote ID
f.HDMI Audio Out :Off
g.SW Input Sensitivity
3
Use the Up and Down [
buttons to select "SP Imped-
ance," and then use the Left and
Right [
4 ohms: Select if the impedance of any
speaker is 4 ohms or more but
less than 6.
6 ohms: Select if the impedances of all
speakers are between 6 and
16 ohms.
4 Press the [SETUP] button.
Setup closes.
SETUP
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
]/[ ]
:Auto
:1
: 0dB
]/[ ]
]/[ ] buttons to select:
47