Tv Format Setup (Not North American Models); Am Frequency Step Setup (On Some Models) - Onkyo TX-SR604 Instruction Manual

First Time Setup—Continued
TV Format Setup
(not North American models)
You must specify the TV system used in your area.
1 Press the [RECEIVER] button,
RECEIVER
followed by the [SETUP] button.
The main menu appears onscreen.
SETUP
2
Use the Up and Down [
buttons to select "8. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
3
Use the Up and Down [
buttons to select "TV Format,"
and then use the Left and Right
[
Auto: Select this to automatically
NTSC: Select if the TV system in
PAL: Select if the TV system in
4
Press the [SETUP] button.
Setup closes.
SETUP
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
48
8.Hardware Setup
------------------------
a.SP Impedance :6ohms
b.PoweredZone2:NotAct
c.TV Format :Auto
d.AM Freq. Step: 9kHz
e.Remote ID :1
f.HDMI Audio Out :Off
g.SW Input Sensitivity
: 0dB
]/[ ] buttons to select:
detect the TV system from the
video input signals.
your area is NTSC.
your area is PAL.
AM Frequency Step Setup
(on some models)
You must specify the AM frequency step used in your
area. Note that when this setting is changed, all radio
presets are deleted.
1
RECEIVER
]/[ ]
SETUP
2
]/[ ]
3
4
SETUP
Note:
• This procedure can also be performed on the AV
receiver by using its [SETUP] button, arrow buttons,
and [ENTER] button.
Press the [RECEIVER] button,
followed by the [SETUP] button.
The main menu appears onscreen.
Use the Up and Down [
buttons to select "8. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
8.Hardware Setup
------------------------
a.SP Impedance :6ohms
b.PoweredZone2:NotAct
c.TV Format :Auto
d.AM Freq. Step: 9kHz
e.Remote ID
f.HDMI Audio Out :Off
g.SW Input Sensitivity
: 0dB
Use the Up and Down [
buttons to select "AM Freq.
Step," and then use the Left and
Right [ ]/[ ] buttons to select:
10 kHz: Select if 10 kHz steps are
used in your area.
9 kHz: Select if 9 kHz steps are used
in your area.
Press the [SETUP] button.
Setup closes.
]/[ ]
:1
]/[ ]