Advanced Setup; Speaker Setup - Onkyo TX-SR604 Instruction Manual

Advanced Setup

Speaker Setup

Some of the settings in this section are set automatically
by the Automatic Speaker Setup function (see page 38).
Here you can check the settings made by the Automatic
Speaker Setup function, or set them manually, which is
useful if you change one of the connected speakers after
using the Automatic Speaker Setup function.
Speaker Configuration
This setting is set automatically by the Automatic
Speaker Setup function (see page 38).
With these settings, you can specify which speakers are
connected and a crossover frequency for each speaker.
The following crossover frequencies can be specified:
Full Band, 40 Hz, 50 Hz, 60 Hz, 80 Hz, 100 Hz, 120 Hz,
150 Hz, 200 Hz.
Specify Full Band for speakers that can output low-fre-
quency bass sounds adequately, for example, speakers
with a good sized woofer. For smaller speakers, specify
a crossover frequency. Sounds below the crossover fre-
quency will be output by the subwoofer instead of the
speaker. Refer to your speakers' manuals to determine
the optimum crossover frequencies.
REMOTE MODE
ON/STANDBY
ZONE2
1
RECEIVER
TAPE
INPUT SELECTOR
1 2 3
V 1 V 2 V 3
4 5 6
V 4 MULTI CH DVD
7 8 9
TAPE TUNER C D
10 11
+ 10
0 CLR
D TUN ENT
--/--- DIMMER SLEEP
CH
TV VOL
DISC
ALBUM
INPUT
GUIDE
TOP MENU
2
ENTER
PLAYLIST/CAT
RETURN
1 Press the [RECEIVER] button fol-
RECEIVER
lowed by the [SETUP] button.
The main menu appears onscreen.
SETUP
DVD
M D/CDR
C D
HDD
T V
VCR
CABLE
12
SAT
VOL
PREVIOUS
MENU
MUTING
2-10
PLAYLIST/CAT
1, 11
SETUP
2
Use the Up and Down [
buttons to select "1. Speaker
Config," and then press [ENTER].
The Speaker Config menu appears.
1.Speaker Config
------------------------
a.Subwoofer
b.Front
c.Center
d.Surround :
e.SurrBack :
f.SurrBack Ch
g.LPFofLFE :
h.DoubleBass
3
Use the Up and Down [
buttons to select "a. Subwoofer,"
and then use the Left and Right
[ ]/[ ] buttons to select:
Yes: Select if a subwoofer is con-
nected.
No: Select if no subwoofer is con-
nected.
4
Use the Up and Down [
buttons to select "b. Front," and
then use the Left and Right [
[ ] buttons to select a crossover
frequency.
Note:
If the Subwoofer setting in step 3 is set
to No, this setting is fixed at Full Band.
5
Use the Up and Down [
buttons to select "c. Center," and
then use the Left and Right [
[ ] buttons to select a crossover
frequency.
If no center speaker is connected, select
None.
Note:
If the Front setting in step 4 is set to
anything other than Full Band, Full
Band cannot be selected here.
]/[ ]
:Yes
: 100Hz
: 100Hz
100Hz
100Hz
:2ch
120Hz
:---
]/[ ]
]/[ ]
]/
]/[ ]
]/
67