Setting The Powered Zone 2 - Onkyo TX-SR705 Instruction Manual

Zone 2

Setting the Powered Zone 2

To use Zone 2, you must make this setting. It enables the
speakers connected to the ZONE 2 SPEAKERS termi-
nals so that they produce sound when Zone 2 is used.
1
Press the [RECEIVER] button fol-
lowed by the [SETUP] button.
The main menu appears onscreen.
2
Use the Up and Down [
buttons to select "7. Hardware
Setup," and then press [ENTER].
The Hardware Setup menu appears.
ENTER
ENTER
3
Use the Up and Down [ ]/[ ]
buttons to select "2. Zone2," and
then press [ENTER].
The Zone2 menu appears.
ENTER
ENTER
4
Use the Left and Right [
buttons to select:
Not Act: ZONE 2 SPEAKERS termi-
When Zone 2 is activated and turned on
(see below), the speakers connected to
the ZONE 2 SPEAKERS terminals
output sound, but the speakers con-
nected to the SURR BACK SPEAK-
ERS terminals do not (when Zone 2 is
activated but not used, the surround
back speakers work as normal).
100
7. Hardware Setup
1. Remote Control
2. Zone2
3. Tuner
4. Analog Multich
5. HDMI
7–2. Zone2
Powered Zone2 Not Act
nals deactivated.
Act: ZONE 2 SPEAKERS termi-
nals activated.
5
Note:
This procedure can also be performed on the AV
receiver/AV amplifier by using its [SETUP] button,
arrow buttons, and [ENTER] button.
]/[ ]
]/[ ]
Press the [SETUP] button.
The setup menu closes.