Multichannel Dvd Input Settings; Audio Adjust Functions - Onkyo TX-SR604 Instruction Manual

Advanced Setup—Continued

Multichannel DVD Input Settings

1 Press the [RECEIVER] button fol-
RECEIVER
lowed by the [SETUP] button.
The main menu appears onscreen.
SETUP
2
Use the Up and Down [ ]/[ ]
buttons to select "8. Hardware
Setup," and then press [ENTER].
Use the Up and Down [ ]/[ ]
buttons to select "SW Input Sen-
sitivity," and use the Left and
Right [
value.
3 Press the [SETUP] button.
Setup closes.
SETUP
SW Input Sensitivity
Some DVD players output the LFE channel from their
subwoofer output at 15 dB higher than normal. You can
change the subwoofer sensitivity to match your DVD
player. Note that this setting only affects signals con-
nected to the SUBWOOFER input jack of the multi-
channel DVD input.
You can select 0 dB, 5 dB, 10 dB, or 15 dB.
If you find that your subwoofer is too loud, try the 10 dB
or 15 dB setting.
72
]/[ ] buttons to select a

Audio Adjust Functions

Here you can set listening mode-related settings and
functions.
1 Press the [RECEIVER] button fol-
RECEIVER
lowed by the [SETUP] button.
The main menu appears onscreen.
SETUP
2
Use the Up and Down [
buttons to select "5. Audio
Adjust," and then press [ENTER].
The Audio Adjust menu appears.
5.Audio Adjust
------------------------
a.Multiplex :
b.Mono Input Ch: L+R
c.PL x Panorama
d.PL x Dimension
e.PL x Center Width:3
f.Neo:6 CenterImage:2
g.Dolby EX
h.T-D Listening Angle
3
Use the Up and Down [
buttons to select the settings,
and use the Left and Right [
[ ] buttons to set them.
The settings are explained on page 73.
4
When you've finished, press the
[SETUP] button.
The setup menu closes.
SETUP
Note:
This procedure can also be performed on the AV receiver
by using its [SETUP] button, arrow buttons, and
[ENTER] button.
]/[ ]
Main
:Off
: 0
: Auto
: Wide
]/[ ]
]/