Fitting The Furniture Door - Miele FN 35402 i Operating And Installation Instructions

Only for an appliance with a niche
height greater than 140 cm
For additional stability of the appliance
in the unit, push the rods supplied in
underneath the appliance between it
and the floor of the housing unit:
 Then secure handle  to one of the
rods .
 Use the handle to push the rod into
the guide as far as it will go. Remove
the handle and fit it to the other rod
and push this into its guide as far as
it will go.
Important. Keep the handle some‐
where safe in case you ever need to
fit the appliance into a new housing
unit.
 Close the appliance door.
Installing the appliance

Fitting the furniture door

The furniture door must be at least
16 mm thick and not exceed 19 mm
thick.
The following gap dimensions must be
maintained:
– The gap between the furniture door
and the unit door above must be at
least 3 mm.
– The vertical gap between furniture
doors should also be about 3 mm.
The exact dimension will vary de‐
pending on the radius of the furniture
door edges.
If fitted in a run of units make sure that
the top edge of the furniture door is at
the same height as neighbouring unit
doors.
The furniture door must be fitted cor‐
rectly and not under tension.
75