Setting The Temperature - Miele FN 35402 i Operating And Installation Instructions

Setting the temperature

 Use the two sensors underneath the
display to set the temperature.
By touching the sensor
– the temperature will get colder,
– the temperature will get warmer.
The temperature being set will flash in
the display.
The following information shows in the
display while the sensors are being
touched:
– Touching a sensor once: the last
temperature selected flashes.
– Each subsequent touch of the sen‐
sor: adjusts the temperature shown
in 1°C steps.
– Leaving a finger on the sensor
changes the temperature continuous‐
ly.
Approximately 5 seconds after the last
time a sensor has been touched, the
current temperature inside the appli‐
ance is automatically shown.
Or
 Touch the OK sensor to confirm your
selection.
The correct temperature
If you have adjusted the temperature,
wait for approx. 6 hours if the appli‐
ance is not very full and for approx.
24 hours if the appliance is full before
checking the temperature display, as it
will take this long for the appliance to
give an accurate reading.
 If, after this time, the temperature is
still too high or too low, you will need
to adjust it again.
Temperature range
The temperature can be adjusted from
-15 °C to -28 °C.
21