Fitting A Furniture Door - Miele F 9052 i Operating And Installation Instructions

Building in the appliance
– screw two long 4 x 19 mm chip
board screws b loosely into the
middle of the long slot on the plastic
bracket and then turn the plastic
bracket downwards,
– Align cover strip d so that it is
parallel to the housing unit ceiling.
The cover strip must not protude.
– screw screws c up into cover strip
d.
^ Close the appliance door.

Fitting a furniture door

^ A gap of 8 mm a must be set
between the appliance door and the
fixing bracket.
^ Push fitting aids d up to the height of
the furniture door: the lower edge "X"
of the fitting aids must be at the same
height as the upper edge of the
furniture door being fitted - see - on
the diagram.
42
^ Undo nuts b, and remove fixing
bracket c, together with the fitting
aids.
^ Using a pencil, lightly mark a line
down the centre of the inside of the
furniture door.
^ Hang the fixing bracket with the
fitting aids a onto the inside of the
furniture door. Align the fixing bracket
centrally.
^ Attach the fixing bracket securely
using at least 6 short 4 x 14 mm chip
board screws b. (On cassette doors
only use 4 screws on the edges).
^ Pull the fitting aids upwards to
remove them c.
^ Turn them around and fit them into
the middle slots on fixing bracket d.