Table of Contents
Advertisement
Operation
Operation
Pressure Washer Location
This pressure washer must have at least five
feet of clearance from combustible material.
Leave at least three feet of clearance on all
sides of the pressure washer to allow for
adequate cooling, maintenance and
servicing.
Place the pressure washer in a well-
ventilated area. DO NOT place the pressure
washer near vents or intakes where exhaust
fumes could be drawn into occupied or
confined spaces. Carefully consider wind
and air currents when positioning pressure
washer.
Starting the Engine
1.
Make certain the pressure washer is on a
flat, level surface.
2. Connect the pressure washer to the
garden hose and turn on the water
supply. Never start or run the pressure
washer if the water supply is
disconnected or turned off.
3. Flip engine switch to "ON" postion
4. Move the choke lever to the "Choke"
position.
5. Pull the starter cord slowly until
resistance is felt and then pull rapidly
6. As engine warms up, move the choke
lever to "Run".
7. Move the throttle lever to the "Open"
position.
NOTE
If the engine starts but does not run, make
certain that the pressure washer is on a flat, level
surface. The engine is equipped with a low oil
sensor that will prevent the engine from running
when the oil level falls below a critical threshold.
10
High Pressure Wash
CAUTION
Always engage the trigger safety latch when the
unit is not in use.
The trigger safety latch prevents the gun from
being triggered accidentally. Push the latch fully
down to engage it.
Pressure Adjustment
Your unit is equipped with an adjustable fan
nozzle. By sliding the nozzle forward or
backward you can adjust the pressure of the
spray. Slide out for high pressure, slide in for
low pressure. (see diagram below)
Adjusting the Spray Fan Angle
The spray end of the wand can be rotated to
have a narrow high impact stream to a 60°
wide fan spray
A narrow stream has high impact force on
the cleaning surface and results in maximum
deep cleaning in a concentrated area.
CAUTION
The narrow high impact spray can damage some
surfaces.
A wide fan pattern distributes the impact of
the water over a larger area resulting in
excellent cleaning action with reduced risk
of surface damage. Clean large surface areas
quickly using a wide fan pattern.
Distance from Cleaning Surface
The distance between the spray nozzle and
the cleaning surface is another factor that
affects the impact force of the water. The
impact force of the water increases as the
Rev C24065-20080409
Advertisement
Table of Contents
