Menu List - Brother GT-341 Instruction Manual

2-7-2. Menu List

Push either one of the OK Button, Up Button, Down Button and Back Button to go into the Menu.
Menu
Head Cleaning
Test Print
Daily Cleaning White
White Agitation
Print Data Load
Print Direction
Maintenance
Printer Setting
Executes Head Cleaning of either one by one or of all four Print Heads.
See "7-2-2. Cleaning the Print Heads"
Normal: normal mis-firing
Powerful: After cleaning the Print Head nozzles, when normal head cleaning does not work.
Prints to check mis-firing and print quality.
Nozzle Check CMYK / W: shows mis-firing
Standard Check CMYK / W: shows general print quality
Whiteness: confirms the white quality
Head Test CMYK / W: confirms which print head is broken
Flushes the " thinner and white-less" dull White Ink caused by sinking white pigment. See
"6-2-1. Daily Cleaning White for replacing dull White Ink".
You can save the waste of the White Ink by moving the Carriage with [ White Agitation ] menu.
See "6-2-2. White Agitation to save the waste (Firmware ver. 3.00 or higher)".
Reads a print data (AR3 file) in USB flash drive. The inside folder shows with [...].
Sets the print direction. This setting is prior to Printer Driver setting.
Auto： Default Bi-directional, Printer Driver setting is available.
Always Uni-Directional: always prints uni-directionally.
Always Bi-Directional: always prints bi-directionally. See "7-2-4. Changing the Print
Direction".
Goes into the Maintenance submenu.
White Tube Cleaning： Cleans the pigment in White Print Heads and Tubes.
See "6-2-3. White Tube Cleaning."
Load White： Loads White Ink into the Tubes filled with Maintenance Solution
after White Tube Cleaning. See "6-2-3. White Tube Cleaning"
Initial Cleaning： Loads ink into the empty new Tubes and Print Heads. CMYK ink
is loaded directly into Tubes. Maintenance Solution is
required before White ink.
Maintenance Parts Exchange: See "6-1-2" to "6-1-7".
Reset CMYK Filter: Resets the warning after you replace K/C or M/Y Filter with the new.
Nozzle Cleaning: Select this menu when you cannot solve mis-firing. See
"7-2-6. Cleaning the Print Head Nozzles"
CR Encoder Strip Cleaning: See "6-1-7. Cleaning the Encoder Strip".
Head Replacement: See "7-2-7. Replacing the Print Head"
Color Tube Cleaning: See "7-2-7. Replacing the Print Head"
Log Copy to USB: See "7-2-13. Copy Log file to USB flash drive"
Goes into the Printer Setting.
LCD Contrast: Adjusts the Display contrast. See "3-4-1. Adjusting the Display
Contrast"
Speaker Volume: Adjusts the speaker volume. See "3-4-2. Adjusting the Speaker
Volume".
Temperature: Sets Fahrenheit / Centigrade. See "3-4-3. Temperature".
Auto Cleaning Interval: See "7-2-5. Changing the Auto Cleaning Setting ".
CR Speed Adjustment: Adjusts the increase/decrease of the Carriage speed. See
"7-2-9. Adjusting the CR Speed".
Content
GT-3 Series
2. Identifying Your Printer's Parts
(Continued on the next page)
15