Brother GT-341 Instruction Manual page 174

7. Troubleshooting
Error
Message
code
5406
5411
5412 Machine Error
5413
5414
5421
Machine Error
5422
5431
5432
5433 Machine Error
5434
5435
5441
5442 Machine Error
5443
5451
5452 Machine Error
5453
5454
5455
Machine Error
5456
5457
5458 Machine Error
5471
5472
5473
5474
Machine Error
5475
5476
5477
5478
164
Meaning
Communication error between
Main PCB and Maintenance Unit
Failure of moving Pump in the
Maintenance Unit
Failure of moving Caps in the
Maintenance Unit
Failure of moving Wipers in the
Maintenance Unit
Internal error of Maintenance Unit
caused by firmware update
Communication error between
Main PCB and the Maintenance
Unit caused by firmware update
Internal error of Maintenance Unit
caused by firmware update
Communication error between
Maintenance Unit and Ink Sensor
PCB
GT-3 Series
Solution
Confirm if there is any device around GT-3 that
makes strong noise. Move GT-3 from that device.
Contact your dealer or Brother when the issue was
not solve after you rebooted GT-3.
Contact your dealer or Brother when the issue was
not solve after you rebooted GT-3.
Confirm if the Wiper Cleaners and Wiper Blades
are properly mounted in the Maintenance Unit.
Confirm that something may prevent the Caps
moving up and down.
Contact your dealer or Brother when the issue was
not solve after you rebooted GT-3.
Confirm if the Wiper Cleaners and Wiper Blades
are properly mounted in the Maintenance Unit.
Confirm that something may prevent the Caps and
Wipers moving.
Contact your dealer or Brother when the issue was
not solve after you rebooted GT-3.
Confirm if there is any device around GT-3 that
makes strong noise. Move GT-3 from that device.
Reboot GT-3 and re-upgrade the firmware.
Contact your dealer or Brother when the issue was
not solve after you rebooted GT-3.
Confirm if there is any device around GT-3 that
makes strong noise. Move GT-3 from that device.
Contact your dealer or Brother when the issue was
not solve after you rebooted GT-3.