Brother GT-341 Instruction Manual page 153

(7) Wet the surface (nozzle plate) of the Print Head with Wash Liquid. Then rub softly the nozzle plate to remove
ink and debris (clogged ink) from the nozzle plate until the nozzle plate is clean. Use a soft, clean and lint-free
cloth to loosen and remove the dirty ink and debris from the Clean Applicator to keep its surface clean and
wet again with Wash Liquid. Use one Clean Applicator for each color.
<Note>
The W3 and W4 Nozzles Plates of GT-381 are hard to be seen from the stop position. Move the Carriage to
the left by your hand to the position where you can clean the Nozzles easily.
<Note>
Pay attention not to touch or stain the Clearance Sensor in cleaning.
(8) Check and clean around the Caps and Wipers. You can use both Clean Applicator (round form with white
grip) and Clean Stick (flag form with green grip). (See "6-1-2. Replacing the Wiper Cleaner and Cleaning the
Caps / Wipers"). Wipe off the front/back of the Clearance Sensor and around the Platen with a soft wet cloth
with water.
(9) Push the Stop Lever to release the lock when you close the Front Cover with both hands.
(10) Turn ON the printer, and initialization will start and the Carriage will move to the original position (on the
Maintenance Unit).
(11) Execute Powerful Cleaning of all the Print Heads to remove the air bubbles in the nozzles. Print Nozzle Check
Pattern to confirm the print quality. (See "7-2-3. Checking Print Quality with Nozzle Check Pattern"). Execute
Head Cleaning if necessary.
Clearance Sensor
GT-3 Series
7. Troubleshooting
W3 and W4
143