Personal Safety - Pacific hydrostar 95338 Assembly And Operating Instructions Manual

modify the plug in any way. Do not use any adapter plugs. Check with a quali-
fied electrician if you are in doubt as to whether the outlet is properly grounded. If
the tools should electrically malfunction or break down, grounding provides a low
resistance path to carry electricity away from the user.
Avoid body contact with grounded surfaces such as pipes, radiators, ranges, and re-
2.
frigerators. There is an increased risk of electric shock if your body is grounded.
Do not expose power tools to rain or wet conditions. Water entering a power tool
3.
will increase the risk of electric shock.
Do not abuse the Power Cord. Never use the Power Cord to carry the tools or pull
4.
the Plug from an outlet. Keep the Power Cord away from heat, oil, sharp edges,
or moving parts. Replace damaged Power Cords immediately. Damaged Power
Cords increase the risk of electric shock.
When operating a power tool outside, use an outdoor extension cord marked "W-
5.
A" or "W". These extension cords are rated for outdoor use, and reduce the risk
of electric shock.
Stay alert. Watch what you are doing, and use common sense when operating a
1.
power tool. Do not use a power tool while tired or under the influence of drugs,
alcohol, or medication. A moment of inattention while operating power tools may
result in serious personal injury.
Dress properly. Do not wear loose clothing or jewelry. Contain long hair. Keep
2.
your hair, clothing, and gloves away from moving parts. Loose clothes, jewelry, or
long hair can be caught in moving parts.
Avoid accidental starting. Be sure the Power Switch is off before plugging in. Car-
3.
rying power tools with your finger on the Power Switch, or plugging in power tools
with the Power Switch on, invites accidents.
Remove adjusting keys or wrenches before turning the power tool on. A wrench or
4.
a key that is left attached to a rotating part of the power tool may result in personal
injury.
Do not overreach. Keep proper footing and balance at all times. Proper footing and
5.
balance enables better control of the power tool in unexpected situations.
Use safety equipment. Always wear eye protection. Nonskid safety shoes, hard
6.
hat, or hearing protection must be used for appropriate conditions. Always wear
ANSI approved safety impact goggles and thick rubber boots during use and main-
tenance.
for technical questions, please call 1-800-444-3353;
SKU 95338
troubleshooting section at end of manual.

PERSOnAl SAfEty

PAGE 4