Pacific hydrostar 95338 Assembly And Operating Instructions Manual page 11

SPRAy WAnd (31c)
tURbO WAnd (30c)
Insert the Spray Wand (31c) or Turbo Wand (30c) into the Water Gun (18a), and
3.
twist the Wand into the Extension until the Wand locks in place. Pull the Wand to
make certain it is secure. (See Figure E.)
bRUSH WAnd
If using the Brush Wand (28c), insert the Brush Wand into the Brush Adapter (29c)
4.
and twist the Wand into the Adapter until the Wand locks in place. Then insert the
Adapter into the Water Gun (18a), and twist the Adapter into the Extension until
the Adapter locks in place. Pull the Wand to make certain it is secure. The Brush
Wand is used to apply detergent at low pressure. (See Figure F.)
lEft SIdE VIEW
OUtlEt
PIPE (47b)
Attach the High Pressure Hose (2c) to the Outlet Pipe (4B) on the left/lower side
5.
of the Pressure Washer. Attach the male part of the Quick Connector Set (3a) to
the right/ lower side of the Pressure Washer. Screw the female part of the Quick
Connector Set onto a heavy duty garden hose (not included). Then, attach the
male part of the Quick Connector Set to the female part of the Quick Connector
Set. (See Figure G.)
for technical questions, please call 1-800-444-3353;
SKU 95338
troubleshooting section at end of manual.
fIgURE E
(28c)
bRUSH
AdAPtER (29c)
fIgURE f
MAlE
QUIck cOUPlER
fIgURE g
WAtER gUn (18A)
WAtER gUn (18A)
RIgHt SIdE VIEW
(3a)
fEMAlE
QUIck
cOUPlER
HEAVy dUty
HOSE
(nOt InclUdEd)
PAGE 11