Pacific hydrostar 95338 Assembly And Operating Instructions Manual page 25

be cERtAIn to shut off the Pressure Washer, release all pressure in a safe manner, and
disconnect it from power and water before adjusting, cleaning, or repairing the unit.
POWER SUPPly
InAdEQUAtE
H a v e a c e r t i f i e d
electrician correct
the problem.
Pressure washer does not build pressure
HOSE IS kInkEd
OR ScREEn IS
clOggEd
clean Screen and
s t r a i g h t e n h o s e .
Switch to a shorter
hose, if possible.
cOnnEctIOnS
connections.
If the steps above do not solve the problem or if the repairs involved are
SKU 95338 for technical questions, please call 1-800-444-3353.
troubleshooting
IMPORtAnt!
Pressure Washer will not start
dry self thoroughly and check the
voltage at the outlet, and the reset button
on the gfcI power plug (explained under
Controls and Features, #2 on page 12).
RESEt bUttOn nOt
SEt cORREctly
Setup the gfcI plug
as explained on page
12.
check that hose is unbent and
Inlet Screen is free from debris
and deposits.
ARE lOOSE
Retighten
too complex, contact a qualified technician.
(continued)
If the power switch is in
the On position and lit, the
thermal safety Switch may
be tripped. Switch the unit
off and allow the unit to rest
for 20-30 minutes and retry.
HOSE IS nOt kInkEd And
ScREEn IS clEAn
Air may be getting in the
water supply hose, check all
connections.
Internal valves, seals, or the
nozzle may be worn, contact
a qualified technician.
POWER SUPPly
AdEQUAtE And RESEt
bUttOn SEt PROPERly
All cOnnEctIOnS
ARE tIgHt
PAGE 25