Controls And Setup - Pacific hydrostar 95338 Assembly And Operating Instructions Manual

Hide thumbs

Table of Contents

Available languages

note: Familiarize yourself with the location and function of all of the machine's controls

before proceeding to setup of the machine.

The Pressure Washer features an automatic On/Off Micro Switch (65b). The Motor

(a) of the Pressure Washer does not run continuously, but only when the Trigger

(21c) is squeezed. When spraying water through the unit stops, the Motor will

automatically shut off.

The Pressure Washer features a

3-Prong, Ground Fault Circuit Inter-

rupter (GFCI) Power Plug (35a). The

GFCI Power Plug provides additional

protection from the risk of electrical

shock. Make sure that the Trigger

(21c) is released before plugging

in. Plug the GFCI Power Plug into a

grounded, 120 volt, electrical outlet.

Press the TEST button and then the

RESET button. The indicator on the

Power Plug should show. If the indi-

cator does not show, have the power

plug inspected by a qualified electri-

cian. Should replacement of the GFCI

Power Plug become necessary, only

a qualified technician should perform

the service. Never attempt to alter or disable the GFCI Power Plug.

(See Figure H.)

The Pressure Washer is equipped with

a Trigger Safety Lock (22c). When

the Trigger (21c) is not squeezed,

the Safety Lock should be pressed

all the way in to help prevent children

from using the tool. To disengage the

Safety Lock, press the opposite side.

(See Figure I.)

The adjustable Nozzle on the Spray

Wand (31c) can be rotated for a range of spray patterns, from a full fan spray to a

direct stream spray. (See Figure J, next page.)

Also, the adjustable nozzle can be slid out for low-pressure spray and detergent

application, or pulled in for normal high-pressure spray. (See Figure J.)

for technical questions, please call 1-800-444-3353;

SKU 95338

troubleshooting section at end of manual.