Specific Safety Rules - Pacific hydrostar 95338 Assembly And Operating Instructions Manual

1. Maintain a safe working environment. Keep the work area well lit. Make sure
there is adequate surrounding workspace. Always keep the work area free of ob-
structions, grease, oil, trash, and other debris. Do not use the Pressure Washer in
areas near flammable chemicals, dusts, and vapors.
2. Maintain labels and nameplates on the Pressure Washer. These carry important
information. If unreadable or missing, contact Harbor Freight Tools for a replace-
ment.
3. WARNING! Risk of injection or severe injury. Keep clear of Nozzle. Do
not direct discharge stream at people or animals. Keep the work area clear of
all people and animals.
4. Use the right product for the right job. There are certain applications for which
this product was designed. Do not use small equipment, tools, or attachments to
do the work of larger industrial equipment, tools, or attachments. Do not use this
product for a purpose for which it was not intended.
5. this product must continuously run with cold water only. never use hot wa-
ter. dry running will cause serious damage to the seals. Make sure the water
supply used for the Pressure Washer is not dirty, sandy, and does not contain any
corrosive chemical products.
6. to avoid electrical shock, never start and run the Pressure Washer in the rain.
Never allow water to leak inside the Body of the Pressure Washer. Do not direct dis-
charge stream at the Pressure Washer itself or at other live electrical equipment.
. do not allow the gfcI Plug (35a) to become wet. Always place the gfcI Plug
in a dry location and as far away as possible from the object being sprayed.
Keep all electrical connections dry and off the ground.
8. When using the Pressure Washer, always maintain a firm grip on the Wash
gun (18a) with both hands. Squeezing the Trigger of the Wash Gun causes a
kickback force.
9. do not pull or carry the Power Washer by its Power cord (35a), or pull the cord
around sharp corners or edges. Do not unplug the Power Washer by pulling on
the Cord. Keep the Cord away from heated surfaces.
10. do not handle the gfcI Plug (35a) with wet hands.
11. Avoid unintentional starting. Make sure you are prepared to begin work before
turning on the Pressure Washer.
12. the work area should have adequate drainage to reduce the possibility of a
fall due to slippery surfaces.
13. this Pressure Washer is intended for outdoor residential use only.
for technical questions, please call 1-800-444-3353;
SKU 95338
troubleshooting section at end of manual.

SPEcIfIc SAfEty RUlES

PAGE 6