Pacific hydrostar 95338 Assembly And Operating Instructions Manual page 26

be cERtAIn to shut off the Pressure Washer, release all pressure in a safe manner, and
disconnect it from power and water before adjusting, cleaning, or repairing the unit.
cOnnEctIOnS
ARE lOOSE
Retighten
connections.
clean tip, using the
included tip cleaning
wire.
nOn-PRESSURE
WASHER dEtERgEnt
USEd
Remove the Handle
(28a) and thoroughly
rinse out the detergent
bottle and passages.
Refill with correct
detergent.
If the steps above do not solve the problem or if the repairs involved are
SKU 95338 for technical questions, please call 1-800-444-3353.
troubleshooting
IMPORtAnt!
Pressure changes during use
Air may be getting in the water supply
hose, check all connections.
tIP IS
dIRty
detergent will not dispense
Verify that proper type of pressure
washer detergent is being used, and
that the appropriate wands/settings are
being used, see page 13, #6.
IncORREct WAndS/
SEttIngS USEd
Set up the washer as
explained on page 13.
too complex, contact a qualified technician.
(continued)
All cOnnEctIOnS
ARE tIgHt
check that tip is free from
debris and deposits.
Internal valves or seals may
be worn or sticking, contact
a qualified technician.
Remove the Handle (28a)
and check that the suction
tube is not bent or pinched.
tIP IS
clEAn
cORREct dEtERgEnt,
WAndS, And SEttIngS
USEd
PAGE 26