Shutting Off The Engine; Adjusting The Turf-Compensation Spring - Toro Reelmaster 5010-H Operator's Manual

Shutting Off the Engine

1. Move all controls to N
to the L
Allow the engine to idle for 5 minutes before shutting it off after a full load operation.
Failure to do so may damage engine components.
2. Turn the key in the switch to the O

Adjusting the Turf-Compensation Spring

The turf-compensation spring transfers the weight from the front roller to the rear roller. This
helps to reduce a wave pattern in the turf, also known as marcelling or bobbing.
Make spring adjustments with the cutting unit mounted to the traction unit, pointing
straight ahead and lowered to the ground.
1. Make sure that the hairpin
rear hole in the spring rod
Note:
the hairpin to the spring-rod hole next to the
turf-compensation spring
2. Tighten the hex nuts
spring rod until the compressed length of the
spring is 15.9 cm (6.25 inches).
Note:
decrease the spring length by 13 mm (1/2 inch). Ground following will be slightly
decreased.
Note:
Aggressiveness of Cut setting is changed.
3464-478A
EUTRAL
I position and allow the engine to reach low idle speed.
OW DLE
When servicing the cutting unit, move
on the front end of the
When operating on rough terrain
The turf compensation setting will need to be reset if the HOC setting or the
, engage the parking brake, move the engine-speed switch
IMPORTANT
position and remove the key.
FF
IMPORTANT
is installed in the
.
.
Page 5–22
G402845
Operation: During Operation