Drawer Front - Fisher & Paykel DishDrawer DD24D Series Service Manual

599735A
Connector Location
P
2
0
4
P
2
0
3
P
2
0
2
8.2

Drawer Front

1. Open the drawer.
2. Locate the drawer pins on either side of the tub.
If the pins cannot be accessed, remove the tub from the
slide first (refer to Section 8.6).
3. Use pliers to pull on the pin and remove it. Support the
drawer front with your hand while doing this to prevent it
dropping onto the floor.
4. With both pins removed, the bottom of the drawer front can
now be eased downward slightly.
5. Pull the drawer front down to free it from the handle and
the top locating slots in the tub.
6. Remove the earth wire from the tab on the drawer front. (If
it is an integrated model, it will be necessary to unplug the
integrated badge from the badge isolator.)
Refit in reverse manner, ensuring the earth wire is
reconnected, drawer slides are fully forward and the pins
secure through the hooks on the front end of the slides.
Note: When reinserting the pins, ensure that the dividing web
is vertical as shown.
P302 P303
Connector
P101
P205
P201
P303
P302
P202
P203
P204
Controller
(Front View)
P201 P205
Harness
Power
Chassis
Motor
LCD/Badge
Comms
Water Softener
Fan
Dispenser
46
P101