Caution! When servicing the DishDrawer, ensure the electrical supply is turned off before attempting
to service or adjust any part of this appliance. Ensure all earth wires that are removed while servicing
are reattached correctly.
8.1 Removing the Drawer Front
1 Open the drawer, using long nose pliers, remove the two
square door pins, one on either side of the tub.
2 Pull the drawer front out slightly at the base and in a
downwards motion.
3 The door outer will release from the tub.
4 Remove the earth terminal from the door.
8.2 Dissassembly of the Inner Door Panel
1 Remove the drawer front (refer section 8.1) and
disconnect the display harness from the wash
controller.
2 Lay the door panel on a flat padded surface to stop
any damage to the door outer.
3 Remove all the screws down each side of the inner
door panel, which includes the brackets, and the
centre screws at the top of the panel. (Fig 1)
4 Remove the plastic rivet inserts at the base of the
door panel. (Fig 2)
5 To remove the inner panel, press down on the side
panel area close to the side bracket and slide the
panel down to release. If the panel is tight to remove
you can use a small flat blade screwdrive to help
free the panel, but take care not to damage the door
panel. (Fig 3)
https://vimeopro.com/fisherpaykeltechnical/training-videos/
video/173779838
51
8 SERVICING PROCEDURES
Fig 1
Fig 2
Fig 3