Servicing The Components; Removing The Front Kickstrip Panel; Removing The Top Panel; Removing The Side Panels - Fisher & Paykel DW60FC1 Service Manual

Warning!
When servicing the DW60 dishwasher, ensure all health and safety requirements are followed. When
removing outer panels or making any component adjustments, ensure the power is switch off to the
appliance.
For some servicing procedures, the dishwasher may need to be disconnected and removed from the
joinery. Ensure you take precautions to ensure you do not damage floor linings with sharp edges.

8.1 Removing the Front KickStrip Panel

Pull the product slightly from the joinery, and tilt
•
backwards.
Unclip the tabs on both sides. Removing the
•
levelling foot may make this easier.
With the clips disengaged pull the kickstrip panel
•
forward to release it.

8.2 Removing the Top Panel

Remove the product from the joinery to gain
•
access to the rear screws.
Remove the screws from each rear bracket.
•
Slide the top panel backwards approx 10mm to
•
release the side tags.
Lift the top panel clear.
•

8.3 Removing the Side Panels

Remove the front kickstrip panel (refer
•
section 8.1)
Remove the top panel (refer section 8.2).
•
Remove the top screws securing the side
•
panel to the chassis.
Remove the rear and front screws retaining
•
the side panel.
The side panel will now be removed.
•

8 SERVICING THE COMPONENTS

retaining clips
rear bracket screw
screws
SCREW
D
29