Drawer Front; Handle And Lcd Display - Fisher & Paykel DishDrawer DD247 Service Manual

58

9.2 Drawer Front

Open the drawer
1.
Locate the drawer pins on either side of the tub.
2.
If the pins cannot be accessed due to being close to
3.
a wall, remove the tub from the slides first (refer p59,
section 9.6).
Use pliers to pull on the pin and remove it from the
4.
side of the tub.
Support the drawer front with your hand while doing
5.
this to prevent it dropping onto the floor.
Pull the drawer front down to free it from the handle
6.
and the top locating slots in the tub.
Remove the earth wire from the tab on the drawer
7.
front. If it is an integrated or flat door model, it will be
necessary to unplug the integrated badge from the
badge isolator.
Refit in reverse manner, ensuring the earth wire is
8.
reconnected, drawer slides are fully forward and the
pins secure through the hooks on the front end of the
slides.
NOTE: When reinserting the pins, ensure that the dividing
web is vertical as shown.

9.3 Handle and LCD Display

Remove the drawer front (refer section 9.2)
1.
Disconnect the LCD wire harness from the controller.
2.
The handle slides onto the flange at the top of the tub.
3.
Push the handle from the right to the left to release it.
The handle may now be lifted clear by pulling it
4.
forwards.
The LCD display is held in place by a wedge with a
5.
spring tab. Without lifting the tab, slide the wedge
downwards using your finger tips to release, the LCD
assembly can now be removed.
The wiring harness can now be unplugged from the
6.
LCD circuit board.
Refit in reverse manner.
7.
D
Slide Handle
left to release
Spring Clip
to release
Slide Wedge
Downwards
D D