Master Tv Setup; Before You Begin; Cloning Methods; Clonable Tv Setup Menu Features - LG 32LG710H Owner's Manual

This section describes how to set up a Master TV for cloning purposes when the TV is in Pass-through
Mode.
Note: Refer to FTG Mode information on pages 33 to 44 for details on entering FTG Mode and
configuring/editing FTG Channel Map and FTG Installer Menu settings.

Before You Begin

• Disconnect all Aux inputs if you intend to run Auto Tuning (Channel Search). Under certain conditions,
Auto Tuning is disabled if there is an Aux input active.
• Determine which cloning tool—USB memory device or clone programmer—is appropriate for your
application; several of the Master TV Setup procedure steps are dependent on the cloning tool to be
used. See "Cloning Methods" below for further information.
• If you intend to use a USB memory device, determine the type of file—either the new ".tlx" file format or
the legacy ".tll" file format—to use for cloning purposes; several of the Master TV Setup procedure steps
are dependent on the desired file type. See "Cloning Methods" below for further information.

Cloning Methods

Using a USB Memory Device / .tlx File
• The .tlx file format clones the following menu settings: Installer Menu settings, IP Environment Offset
Setup and Pro:Centric Setup settings (see pages 45 and 46), and all TV sources' (analog, digital, AV1,
HDMI, etc.) clonable setup menu settings. See "Clonable TV Setup Menu Features" list below.
• Not intended for cloning an auto-tuned/edited Channel Map, as the channel lineup is converted to a logical
FTG Channel Map when saved (Learned) from a TV to a .tlx file. If the .tlx file with the FTG Channel Map
is then used for Teaching purposes, all Target TVs will be configured for FTG Mode via CPU.
Using a USB Memory Device / .tll File
The .tll file format clones the contents of the commercial controller (PTC) memory, including an auto-tuned/
edited Channel Map, Installer Menu settings, and one TV source's (analog, digital, or Aux) clonable setup
menu settings. See "Clonable TV Setup Menu Features" list below.
Using a Clone Programmer (TLL-1100A or LT2002)
Both the TLL-1100A and LT2002 clone the contents of the commercial controller (PTC) memory, including
an auto-tuned/edited Channel Map, Installer Menu settings, and one TV source's (analog or Aux) clonable
setup menu settings. See "Clonable TV Setup Menu Features" list below.

Clonable TV Setup Menu Features

Channel
Auto Tuning (Channel Lineup)
Manual Tuning
Channel Edit
Channel Label
Picture
Aspect Ratio
Picture Mode
Note: Some menu options vary between analog and digital channels and Aux inputs.
206-4200
Audio
Auto Volume
Clear Voice
Sound Mode
Balance
TV Speaker
Time
Auto Clock
Auto Off (Sleep Timer)
Option
Menu Language
Audio Language
Caption
Lock
Movie Rating
TV Rating – Children
TV Rating – General

Master TV Setup

11