Installer Menu - LG 32LG710H Owner's Manual

Master TV Setup (Cont.)
(Continued from previous page)
5. Transfer the TV setup menu settings to the commercial controller (PTC):
2-5-5 + MENU Mode
Important: This step is essential for successful cloning using a USB memory
device / .tll file or a clone programmer. Without this step, the PTC will not
contain any of the TV setup menu settings.
a) After the TV channel lineup has been edited and channel label icons added, tune to
the channel (source) for which you wish to transfer TV setup menu settings.
Note: If you intend to use a clone programmer for cloning purposes, this must be
either an analog channel or Aux input.
b) Enter the Installer Menu, and press 2-5-5 + MENU on the Installer Remote to
initiate the transfer of the Master TV Setup to the PTC. The TV exits the Installer
Menu and then tunes through the channels in the channel lineup during the
transfer. When the transfer is complete, the TV tunes back to the channel that
was tuned before the transfer began.
Note: The maximum number of channels that can be transferred is 141. An attempt to
transfer more than 141 channels will result in erratic TV tuning operation.
6. (Optional) Add Custom Channel and Aux Labels:
2-5-4 + MENU Mode
Note: This step is applicable only if you intend to clone the PTC.
2-5-4 + MENU Mode enables you to add/edit channel icons and cus-
tom text labels in the PTC once the Master TV Setup has been trans-
ferred as described in the previous step.
Enter the Installer Menu, and press 2-5-4 + MENU on the Installer
Remote. Add/edit custom text labels and/or change icons for the
Channel-Time on-screen displays (see 2-5-4 + MENU procedural
information on page 23). Note that broadcast digital channels often
already have a broadcaster generated label. When you are finished,
press MENU to exit 2-5-4 + MENU Mode.
7. Verify the TV setup.
As applicable, verify that the channel lineup, channel icons, and custom
text labels are correct. Also, make sure the TV features are set per your
requirements.
8. Lock the channel lineup.
Enter the Installer Menu. Set item 028 CH. OVERIDE to 000 and
press ENTER to lock the channel lineup and restrict access to the TV
setup menus. Press ENTER again to save your changes and exit the

Installer Menu.*

The Master TV Setup is now ready to be copied to the predetermined
cloning tool—a USB memory device (.tlx or .tll file) or a clone programmer.
See cloning procedures in this document.
14
DIGITAL 19-3
MONO STEREO SAP
WXYZ
Custom text label "WXYZ" created
in 2-5-4 + MENU Mode.
028 CH. OVERIDE
After verifying the TV Setup, set Installer
Menu item 028 CH. OVERIDE to 000.*
*
This step prevents end users from
accessing channel settings (i.e., the
Channel Menu will be inaccessible/
grayed out).
000
206-4200