Hyundai HYC2610 User Manual page 9

Always inspect the chain saw before each use for worn, loose, or changed parts.
Never operate a chain saw that is damaged, improperly adjusted, or is not
completely and securely assembled. Be sure that the saw chain stops moving when
the throttle control trigger is released.
All chainsaw service, other than the items listed in the Operator's Manual, should be
performed by competent chainsaw service personnel. (e.g., if improper tools are
used to remove the flywheel, or if an improper tool is used to hold the flywheel in
order to remove the clutch, structural damage to the flywheel could occur which
could subsequently cause the flywheel to disintegrate).
Always shut off the engine before setting it down.
DO NOT cut small size brush and saplings because slender material may catch the
saw chain and be whipped toward you or pull you off balance.
When cutting a branch that is under tension, be alert for spring back so that you will
not be struck when the tension in the wood fibres is released.
Keep the handle dry, clean and free of oil or fuel mixture.
Guard against kickback. Kickback is the upward motion of the guide bar which occurs
when the saw chain at the nose of the guide bar contacts an object. Kickback can
lead to dangerous loss of control of the chain saw.
When transporting your chain saw, make sure the appropriate guide bar cover is in
place. Securely place the machine during transport to prevent loss of fuel, damage or
injury.
Page 9 Rev 3