Operation - Hyundai HYC2610 User Manual

6. OPERATION

6.1. Starting the Engine.
6.1.1. Untwist and remove the fuel cap (4) and oil cap (5).
6.1.2. Fill the fuel tank (as in section 5) and oil tank to 80% of
the full capacity.
6.1.3. Fasten the fuel cap and oil tank securely and wipe up
any fuel spillage around the unit.
6.1.4. Put the switch to the "I" (ON) position (1).
6.1.5. Pull out the choke knob (2). The choke will close and the
throttle lever will then be set in the starting position.
6.1.6. Continuously push the primer bulb (3) until fuel comes in
the bulb.
Before you start the engine, make sure the saw chain is not touching anything.
Make sure the chain brake is always activated each time you start the engine.
When restarting immediately after stopping the engine. Set choke in the open
position.
Once the choke knob has been pulled out, it will not return to the operating
position even if you press down on it with your finger.
When you wish to return the choke knob to the operating position, operate
the throttle trigger instead.
Page 17 Rev 3