Hyundai HYC2610 User Manual page 14

Pay attention to the correct direction of the saw chain
4.1.6. Adjust the position of chain tensioner nail, and then insert the tensioner nail in the lower
hole of the guide bar. Mount the clutch cover to the power unit and fasten the mounting nut
to finger tightness. While holding up the tip of the bar, adjust the chain tension by turning the
tensioner screw until the tie straps just touch the bottom side of the guide bar (Figure 5).
3 Tensioner Pin
4 Tensioner Screw
4.1.7. Tighten the nut securely with the bar tip held up. Then check the chain for smooth rotation
and proper tension while moving it by hand. If necessary, readjust with the chain cover loose.
Turn the tensioner screw clockwise to tighten the chain, turn the tensioner screw counter-
clockwise to loosen the chain (Figure 6).
Page 14 Rev 3