Hyundai HYC2610 User Manual page 18

6.1.7. Push the front handle guard down toward the front to
activate the chain brake.
6.1.8. While holding the saw unit securely on the ground, pull
the starter rope firmly and do not let go. Instead slowly
release cord into machine body
6.1.9. When firing occur, push in the throttle trigger to allow
the choke return to the running position and pull the
starter handle again to start the engine.
6.1.10. Pull up the front handle guard toward the front handle
to release brake. Then, allow the engine to warm up with
the trigger pulled slightly
1 Throttle Trigger
2 Rear Handle
3 Throttle Trigger Lock
Lever
6.2. Checking chain oil supply.
6.2.1. After starting the engine, run the chain at medium
speed and see if chain oil is scattered off as shown in the
figure (1).
6.2.2. The chain oil flow can be changed by inserting a
screwdriver in the hole on bottom of the clutch side.
6.2.3. Adjust according to your work conditions.
6.2.4. (1) Chain oil flow adjusting screw.
6.2.5. Anti-clockwise – Increase Oil flow.
6.2.6. Clockwise – Decrease Oil flow.
The oil tank should become nearly empty by the time fuel is used up.
Make sure to refill the oil tank every time you re-fuel the chainsaw.
Page 18 Rev 3