Electrical System Maintenance; Servicing The Fuses; Servicing The Headlights - Toro 72211 Operator's Manual

Never install a dirty filter if it is removed from the fuel
line.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Close fuel shut-off valve at fuel tank (Figure 38 ).
4. Open the hood.
5. Squeeze the ends of the hose clamps together and
slide them away from the filter (Figure 39 ).
6. Remove the filter from the fuel lines.
7. Install a new filter and move the hose clamps close
to the filter.
8. Open fuel shut-off valve at fuel tank (Figure 38 ).
9. Close the hood.
Electrical System
Maintenance

Servicing the Fuses

The electrical system is protected by fuses. It requires
no maintenance, however, if a fuse blows check
component/circuit for malfunction or short. To
replace fuses pull up on the fuse (Figure 40 ) to remove
or replace it.
Fuses:
•
Main/Starter F1-30 amp, blade-type
•
Alternator F2-25 amp, blade-type
•
Dash/Hour meter F3-10 amp, blade-type
•
Head lights F4-10 amp, blade-type
•
Power attachment lift F5-25 amp, blade-type
(Model 430 only)
•
Figure 40
1. Main-30 amp
2. Alternator-25 amp
3. Dash/Hour meter-10 amp

Servicing the Headlights

Specification: Bulb #1156 Automotive Type
Removing the Bulb
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Open the hood. Pull wire connectors off both bulb
holder terminals.
4. Rotate the bulb holder 1/4 turn counterclockwise
and remove it from the reflector (Figure 41 ).
5. Push and rotate the bulb counterclockwise until it
stops (approximately a 1/4 turn) and remove bulb
from the bulb holder (Figure 41 ).
32
4. Head lights-10 amp
5. Power attachment
lift-25 amp (Model 72202
only)