Servicing The Air Cleaner - Toro 72211 Operator's Manual

Figure 32
1. Oil drain
6. Clean around the oil dipstick and unscrew the cap
(Figure 31 ).
7. Slowly pour approximately 80% of the specified oil
into the filler cap (Figure 31 ). Refer to Servicing
the Engine Oil in Engine Maintenance, page 28 .
8. Check the oil level; refer to Checking the Engine
Oil Level in Engine Maintenance, page 28 .
9. Slowly add additional oil to bring it to the full mark.
Changing the Oil Filter
Replace the oil filter every 200 hours or every other
oil change.
Note: Change the oil filter more frequently when
operating conditions are extremely dusty or sandy.
1. Drain the oil from the engine; refer to Changing and
Draining the Engine Oil in Engine Maintenance,
page 28 .
2. Remove the old filter (Figure 33 ).
3. Apply a thin coat of new oil to the rubber gasket
on the replacement filter.
Figure 33
1. Oil lter
4. Install the replacement oil filter to the adapter.
Turn the oil filter clockwise until the rubber gasket
contacts the filter adapter, then tighten the filter an
additional 3/4 turn (Figure 33 ).
5. Fill the crankcase with the proper type of new oil;
refer to Changing and Draining the Engine Oil in
Engine Maintenance, page 28 .

Servicing the Air Cleaner

Foam Element: Clean and oil after every 25 operating
hours.
Paper Element: Clean after every 50 operating hours.
Replace after every 200 operating hours or yearly,
whichever comes first.
Note: Service the air cleaner more frequently (every
few hours) if operating conditions are extremely dusty
or sandy.
Removing the Foam and Paper
Elements
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean around the air cleaner to prevent dirt from
getting into the engine and causing damage.
Unlatch the two side latches and remove the air
cleaner cover (Figure 34 ).
Figure 34
1. Cover
2. Foam element
3. Paper element
4. Carefully remove the foam element from the paper
element (Figure 34 ).
5. Unscrew the wing nut and remove the paper
element (Figure 34 ).
29
4. Wing nut
5. Air cleaner base
6. Latches