Installing The Front Tires; Installing The Rear Wheels; Front Tires; Cotter Pin - Toro 72211 Operator's Manual

Figure 6
1. Positive Battery Post
2. Negative Battery Post
9. Install the battery in the tractor and connect the
battery cables. Refer to the Installing the Battery in
Electrical System Maintenance, page 32 .
Note: Do not run the tractor with the battery
disconnected, electrical damage may occur.
Step
4

Installing the Front Tires

Parts needed for this step:
2

Front tires

2

Cotter pin

4

Shim washers

2

Washers, thick

2

Washers

2

Cap

Procedure
1. Remove the tires from the crate (Figure 7 ).
2. Install a thin washer (3/4 inch) onto the axle
(Figure 7 ).
3. Red (+) Charger Lead
4. Black (-) Charger Lead
1. Front wheel
2. Axle
3. Shim washer
4. Thick washer, 3/4 inch
3. Slide wheel onto axle with valve stem in (Figure 7 ).
4. Wheel end play should be 0 to 0.015 inch
(0 to 0.4 mm). Install the shim washers (as
required) and thick flat washer (3/4 inch) for
spacing on the axle.
5. Insert cotter pin through the axle and bend the
ends of the pin open (Figure 7 ).
6. Push the cap onto the end of the axle so it snaps
over washer (Figure 7 ).
7. Repeat steps 2-6 on opposite side.
8. Grease the wheel bearings.
Step
5

Installing the Rear Wheels

Parts needed for this step:
2 Rear tires
10 Lug nuts
Procedure
1. Install the rear wheel onto the wheel hub with the
valve stem to the inside (Figure 8 ).
2. Torque the wheel bolts to 75-80 ft-lb (105-112
N·m).
13
Figure 7
5. Cap
6. Cotterpin
7. Thin Washer, 3/4 inch