Maintenance; Recommended Maintenance; Schedule(S); Lubrication - Toro 72211 Operator's Manual

Maintenance

Recommended Maintenance Schedule(s)
Maintenance
Service Interval
After the rst use
Before each use or
daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Before storage
Important: Refer to your engine operator's manual for additional maintenance procedures.
If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition and disconnect the wire from the spark plug before you do any
maintenance. Set the wire aside so that it does not accidentally contact the spark plug.

Lubrication

Greasing and Lubrication

Grease the machine after every 50 operating hours or
yearly, whichever occurs first. Grease more frequently
when operating conditions are extremely dusty or
sandy.
Grease Type: General-purpose grease.
Maintenance Procedure
• Change the engine oil.
• Check the safety interlock system.
• Check the engine oil level.
• Check the battery electrolyte.
• Clean the air intake screen.
• Check the brake.
• Clean the foam air cleaner element (more often in dusty dirty
conditions).
• Check the tire pressure.
• Grease the front wheels and spindles (more often in dirty or dusty
conditions).
• Clean the paper air cleaner element.
• Change the engine oil (more often in dirty or dusty conditions).
• Check the spark plug(s).
• Replace the fuel lter.
• Clean the cooling ns and engine shrouds.
• Change the oil lter (more often in dirty or dusty conditions).
• Replace the paper air cleaner element.
• Drain the fuel.
• Charge the battery and disconnect the cables.
• Check the toe-in.
• Perform all maintenance procedures listed above before storage.
27
How to Grease
1. Disengage the power take off (PTO), set the
parking brake, and turn the ignition key to off.
Remove the ignition key.
2. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
3. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
4. Wipe up any excess grease.