Using The Headlights; Positioning The Tilt Steering; Wheel; Pushing The Machine By Hand - Toro 72211 Operator's Manual

Figure 24
1. Adjustment knob

Using the Headlights

The headlights are turned on with a separate position,
lights, of the ignition switch (Figure 25 ). The lights are
on while the ignition switch is in the lights position
even with the engine off. Remove the key when the
machine is left unattended so lights can not be turned
or discharging the battery.
Figure 25
1. Lights

Positioning the Tilt Steering

Wheel

The steering wheel has four tilt locations. Position the
steering wheel where you have the best control of the
machine and are most comfortable.
1. Lift the tilt lever to release the lock (Figure 26 ).
2. Move the steering wheel to a comfortable position;
then release the lever to lock.
Figure 26
1. Tilt lever
Pushing the Machine by
Hand
Important: Always push the machine by hand.
Never tow the machine because transaxle damage
may occur.
To Push the Machine
1. Disengage the power take off (PTO) and turn the
ignition key to off.
2. Move the drive control rod to the push position.
This disengages the drive system and allows the
wheels to turn freely (Figure 27 ).
To Operate the Machine
Move the drive control rod to the operate position
(Figure 27 ).
Note: The machine will not drive unless the drive
control rod is in the operate position.
25
2. Steering wheel