Installing The Steering Wheel; Installing The Seat; Step; Steering Wheel - Toro 72211 Operator's Manual

Step

1
Installing the Steering
Wheel
Parts needed for this step:
1

Steering Wheel

1

Lock Washer, 1/2 inch

1

Nut, 1/2 inch

1

Logo Cover

Procedure
1. Position the front wheels straight ahead.
2. Remove the logo cover by releasing the 3 latches
from the back side with a screwdriver.
3. Line up the center spoke toward the seat and
position the steering wheel onto the shaft spline
(Figure 3 ).
Figure 3
1. Center spoke
2. Shaft spline
3. Lock washer, 1/2 inch
4. Secure the steering wheel with a lockwasher
(1/2 inch) and nut (1/2 inch) (Figure 3 ).
5. Torque the steering wheel nut to 50 ft-lb (37 N.m).
6. Snap the logo cover into place (Figure 3 ).
4. Nut, 1/2 inch
5. Logo cover
Step
2

Installing the Seat

Parts needed for this step:
1

Seat

2

Spacer, large inside diameter

2

Spacer, small inside diameter

2

Shoulder bolt

2

Knob

2

Flat washer, 11/32 inch

Procedure
1. Install the large inside diameter spacer and the
2 shoulder bolts into the rear holes of the seat
(Figure 4 ).
1. Seat
2. Spacer-small ID
3. Spacer-large ID
4. Shoulder bolt
5. Knob
2. Position the seat onto the seat base by inserting the
2 shoulder bolts through the key hole openings at
the end of both slots (Figure 4 ).
3. Locate the small inside diameter spacer between
the seat and the seat base, thread the 2 knobs and
2 flat washers (11/32 inch) into the front holes in
the seat (Figure 4 ). Adjust the seat and tighten
the knobs.
11
Figure 4
6. Wire and connector
7. Wire harness connector
8. Wire clip
9. Flat washer, 11/32 inch