Servicing The Battery - Toro 72211 Operator's Manual

Figure 41
1. Bulb holder
2. Reector
3. Tabs
Installing the Bulb
1. The bulb has metal pins on the side of its base.
Align the pins with the slots in the bulb holder and
insert the base into the holder (Figure 42 ). Push
and rotate the bulb clockwise until it stops.
Figure 42
1. Bulb
2. Metal pins
2. The bulb holder has two tabs (Figure 41 ). Align
the tabs with the slots in the reflector, insert the
bulb holder into the reflector and rotate it 1/4 turn
clockwise until it stops.
3. Push the wire connectors onto the terminals on
the bulb holder.
4. Slots
5. Terminals
3. Bulb holder
4. Slots

Servicing the Battery

Warning
CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related accessories
contain lead and lead compounds, chemicals
known to the State of California to cause cancer
and reproductive harm. Wash hands after
handling.
Always keep the battery clean and fully charged. Use
a paper towel to clean the battery case. If the battery
terminals are corroded, clean them with a solution
of four parts water and one part baking soda. Apply
a light coating of grease to the battery terminals to
prevent corrosion.
Voltage: 12 v, 260 Cold Cranking Amps
Removing the Battery
Battery terminals or metal tools could short
against metal tractor components causing
sparks. Sparks can cause the battery gasses to
explode, resulting in personal injury.
•
When removing or installing the battery, do
not allow the battery terminals to touch any
metal parts of the tractor.
•
Do not allow metal tools to short between
the battery terminals and metal parts of the
tractor.
Incorrect battery cable routing could damage
the tractor and cables causing sparks. Sparks
can cause the battery gasses to explode,
resulting in personal injury.
•
Always disconnect the negative (black)
battery cable before disconnecting the
positive (red) cable.
•
Always reconnect the positive (red) battery
cable before reconnecting the negative
(black) cable.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Open the hood and locate the battery.
33