Adjusting The Mirrors; Aiming The Headlights - Toro Groundsmaster 4010 Operator's Manual

floor to the tip of the cutting edge on both
units and compare. These numbers should be
within 3 mm (1/8 inch) of each other. Make no
adjustment at this time.
2. Position blade side to side on inside spindle
of side cutting unit and corresponding outside
spindle of front cutting unit. Measure from the
floor to the tip of the cutting edge on inside edge
of side cutting unit to corresponding outside
edge of front cutting unit and compare. The side
cutting unit measurement should be within 3 mm
(1/8 inch) of the front cutting unit.
Note:
All three cutting units castor
wheels should remain on the ground with
counterbalance applied.
Note:
If adjustments need to be made to match
the cut between the front and side cutting units,
make the adjustments to the side cutting units
only.
3. If the inside edge of the side cutting unit is too
high relative to the outside edge of the front
cutting unit, remove one 3 mm (1/8 inch) shim
from the bottom of the front inside castor arm
on the side cutting unit
measurement between outside edges of both
side cutting units and inside edge of side cutting
unit to outside edge of front cutting unit.
4. If inside edge is still too high, remove an
additional 3 mm (1/8 inch) shim from bottom of
front inside castor arm of the side cutting unit
and one 3 mm (1/8 inch) shim from the front
outside castor arm of the side cutting unit.
5. If the inside edge of the side cutting unit is too
low relative to the outside edge of the front
cutting unit, add one 3 mm (1/8 inch) shim to
the bottom of the front inside castor arm on the
side cutting unit. Check measurement between
outside edges of both side cutting units and
inside edge of side cutting unit to outside edge
of front cutting unit.
6. If inside edge is still too low, add an additional 3
mm (1/8 inch) shim to the bottom of front inside
castor arm of the side cutting unit and add one
3 mm (1/8 inch) shim to the front outside castor
arm of the side cutting unit.
7. Once cutting height matches at the edges of
front and side cutting units, verify that side
cutting unit pitch is still 8 to 11 mm (5/16 to 7/16
inch). Adjust as necessary.
(Figure 31). Recheck

Adjusting the Mirrors

Cab model only
Rear View Mirror
While sitting in the seat, adjust the rear view mirror
(Figure 32) to attain the best view out the rear window.
Pull the lever rearward to tilt the mirror to reduce the
brightness and glare of light.
Side View Mirrors
While sitting in the seat, have a helper adjust the side
view mirrors (Figure
the side of the machine.
1. Side view mirrors
2. Rear view mirror

Aiming the Headlights

1. Loosen the mounting nuts and position each
headlight so that it points straight ahead.
Tighten the mounting nut just enough to hold the
headlight in position.
2. Place a flat piece of sheet metal over the face of
the headlight.
3. Mount a magnetic protractor onto the plate.
While holding the assembly in place, carefully tilt
the headlight downward 3 degrees, then tighten
the nut.
4. Repeat the procedure on the other headlight.
35
32) to attain the best view around
Figure 32
3. Lever
g008870