Adjusting The Mirrors; Aiming The Headlights; Adjusting The Height-Of-Cut - Toro Groundsmaster 4110 Operator's Manual

Adjusting the Mirrors

Cab model only
Rearview Mirror
While sitting in the seat, adjust the rearview mirror
(Figure 14) to attain the best view out the rear window.
Pull the lever rearward to tilt the mirror to reduce the
brightness and glare of light.
Side View Mirrors
While sitting in the seat, have a helper adjust the side
view mirrors (Figure 14) to attain the best view around
the side of the machine.
Figure 14
1. Side view mirrors
2. Rearview mirror

Aiming the Headlights

Optional Accessory
1. Loosen the mounting nuts and position each
headlight so that it points straight ahead.
Tighten the mounting nut just enough to hold the
headlight in position.
2. Place a flat piece of sheet metal over the face of
the headlight.
3. Mount a magnetic protractor onto the plate.
While holding the assembly in place, carefully tilt
the headlight downward 3 degrees, then tighten
the nut.
4. Repeat the procedure on the other headlight.
g008870
3. Lever

Adjusting the Height-of-Cut

Center Mower Deck
The height-of-cut is adjustable from 25 to 127 mm (1
to 5 inches) in 13 mm (1/2 inch) increments. To adjust
the height-of-cut on the center mower deck, position
the castor wheel axles in the upper or lower holes of
the castor forks, add or remove an equal number of
spacers from the castor forks, and secure the rear
chain to the desired hole.
1. Start the engine and raise the mower decks to
change height of cut.
2. Shut off the engine and remove the key after the
mower deck is raised.
3. Position the caster-wheel axles in the same
holes in all caster forks.
1. Tensioning cap
2. Spacers
3. Shims
Note:
When operating in 64 mm (2-1/2 inch)
height-of-cut or higher, install the axle bolt in the
lower caster-fork hole to prevent grass buildup
between the wheel and the fork. When you
operate the machine at a height of cut lower
than 64 mm (2-1/2 inches) and detect grass
buildup, reverse the machines direction to pull
any clippings away from the wheel/fork area.
4. Remove the tensioning cap from the spindle
shaft and slide the spindle out of the caster arm
(Figure 15).
5. Install 2 shims onto the spindle shaft as they
were originally installed.
Note:
These shims require a level across the
entire width of the mower decks. Slide the
appropriate number of 13 mm (1/2 inch) spacers
(refer to the chart below) onto the spindle shaft
26
Figure 15
4. Top axle-mounting hole
5. Caster wheel
g008866