Adjusting The Control Arm Position; Installing The Cutting Units - Toro 03660 Operator's Manual

1. Step
2. Raise or lower the step to the desired height and
re-secure the brackets to the frame with the 2 bolts
and nuts.
3. Repeat the procedure on the other step.
3
Adjusting the Control Arm
Position
No Parts Required
Procedure
The control arm position can be adjusted for the
operators comfort.
1. Loosen the 2 bolts securing the control arm to the
retaining bracket (Figure 3).
Figure 2
2. Step brackets
1. Control arm
2. Retaining brackets
2. Rotate the control arm to the desired position and
tighten the 2 bolts.
4

Installing the Cutting Units

Parts needed for this procedure:
1 Front hose guide-R.H.
1 Front hose guide-L.H.
Procedure
1. Remove the reel motors from the shipping brackets.
2. Remove the shipping brackets and discard.
3. Remove the cutting units from the cartons. Assemble
and adjust as described in the cutting unit Operator's
Manual.
4. Make sure the counter weight (Figure 4) is installed
to the proper end of the cutting unit as described in
the cutting unit Operator's Manual.
13
Figure 3
3. Bolts (2)