Using The Gauge Bar; Reading The Manual And Viewing The Safety Video - Toro 03660 Operator's Manual

1. Chain bracket
2. Snapper pin
9

Using the Gauge Bar

Parts needed for this procedure:
1 Gauge bar
Procedure
Use the gauge bar to adjust the cutting unit. Refer to
the Cutting Unit Operator's Manual for the adjustment
procedures (Figure 20).
Figure 19
3. Cutting unit kickstand
1. Gauge bar
2. Height adjusting screw
3. Nut
10
Reading the Manual and
Viewing the Safety Video
Parts needed for this procedure:
1 Operator's Manual
1 Engine Operator's Manual
1 Parts Catalog
1 CE certificate
1 Operator Training Material
Procedure
• Read the Operator's Manual.
• View the Operator Training Material.
• Store all documentation in a safe place for future use.
• Fill out the registration card.
• Use the diagnostic ACE display overlay when
troubleshooting problems with the machine (store it
in the service shop until needed).
22
Figure 20
4. Holes used for setting
Groomer HOG
5. Hole not used