Service Interval Chart; Lubrication; Greasing The Bearings And Bushings - Toro 03660 Operator's Manual

Service Interval Chart

If you leave the key in the ignition switch, someone could accidently start the engine and seriously
injure you or other bystanders.
Remove the key from the ignition before you do any maintenance.

Lubrication

Greasing the Bearings and
Bushings
If you operate the machine under normal conditions,
lubricate all grease fittings for the bearings and bushings
after every 50 hours of operation with No. 2 General
Purpose Lithium Base Grease. Lubricate bearings and
bushings immediately after every washing, regardless
of the interval listed.
The grease fitting locations and quantities are as follows:
• Pump drive shaft U-joint (3) (Figure 51)
Figure 50
• Cutting unit lift arm cylinders (2 each) (Figure 52)
41
Figure 51
Figure 52