Toro 03660 Operator's Manual page 20

1. Weight
2. Carriage bolt
On four wheel drive models, use the following procedure to mount the appropriate amount of weight (see weight
charts) to the top or bottom of the rear bumper as shown in Figure 15.
1. Traction manifold
2. Spacers
3. Bolts
4. Washers
• Remove the 3 bolts, washers, and spacers securing the traction manifold to the bottom of the rear bumper
(Figure 15a).
• Position the appropriate amount of weight on the top and/or bottom of the rear bumper.
• Mount the weight(s) and the traction manifold to the bumper with the 3 bolts, washers and spacers previously
removed (Figure 15b).
Note: Do not use the spacers when installing more than two weights under the bumper (Figure 15c).
• Secure the outer edges of the weight(s) to the bumper with 2 carriage bolts and nuts (Figure 15c).
Figure 14
3. Nut
Figure 15
5. Weight(s)
6. Carriage bolt
7. Nut
20