Electrical System Maintenance; Servicing The Battery - Toro 03660 Operator's Manual

Figure 65
1. Fuel injectors
2. Turn the key in the key switch to the On position
and watch the fuel flow around the connector. When
you observe a solid flow of fuel, turn the key to the
Off position.
3. Tighten the pipe connector securely.
4. Repeat steps 1 through 3 on the remaining nozzles.
Electrical System
Maintenance
Important: Before welding on the machine,
disconnect both cables from the battery, both wire
harness plugs from the electronic control module,
and the terminal connector from the alternator to
prevent damage to the electrical system.

Servicing the Battery

CALIFORNIA
Proposition 65 Warning
Battery posts, terminals, and related
accessories contain lead and lead compounds,
chemicals known to the State of California
to cause cancer and reproductive harm.
Wash hands after handling.
Battery electrolyte contains sulfuric acid which
is a deadly poison and causes severe burns.
• Do not drink electrolyte and avoid contact
with skin, eyes, or clothing. Wear safety
glasses to shield your eyes and rubber gloves
to protect your hands.
• Fill the battery where clean water is always
available for flushing the skin.
Charging the battery produces gasses that can
explode.
Never smoke near the battery and keep sparks
and flames away from it.
Check the battery condition weekly or after every 50
hours of operation. Keep the terminals and the entire
battery case clean because a dirty battery will discharge
slowly. To clean the battery, wash the entire case with a
solution of baking soda and water. Rinse it with clear
water.
46
Warning