1. Handle
3
Installing the Seat
Parts needed for this procedure:
Seat, Model 30398 and the Mechanical Seat
Suspension Kit, Model No. 30312 or the Pneumatic
1
Seat Suspension Kit, Model No. 30313 (obtained
separately)
Procedure
The Groundsmaster 3280-D is shipped without the seat
assembly. The optional Seat, Model 30398 and the Mechanical
Seat Suspension Kit, Model No. 30312 or the Pneumatic Seat
Suspension Kit, Model No. 30313 must be obtained and
installed. Refer to the seat kit for the installation instructions.
Note: An Auxiliary Power Unit Kit, Model No. 30382,
must be obtained and installed before installing a Pneumatic
Suspension Seat Kit to the machine.
Note: Refer to Installing the Manual Tube before the seat is
mounted to the seat suspension.
Figure 5
2. Hood cable bracket
4
Installing the Seat Belt
Parts needed for this procedure:
2
Seat belt
2
Bolts
2
Lock washer
2
Flat washer
Procedure
Install each end of the seat belt in the holes in the back of the
seat with 2 bolts (7/16 x 1 inch), flat washers (7/16 inch),
and lock washers (7/16 inch) (Figure 6).
Important: Mount the latch side of the belt to the right
side of the seat.
1. Seat belt latch
5
Installing the Manual Tube
Parts needed for this procedure:
1
Manual tube
2
R-clamp
Procedure
1. Remove the manual tube and R-clamps secured to
the seat plate. Discard the 2 mounting bolts and flat
washers.
2. Remove the 2 nuts and vinyl caps (if previously
installed) securing the upper seat bracket to the left side
of the seat suspension (Figure 7).
16
Figure 6