Checking The Bidirectional Clutch Lubricant (Model 30345 Only); Using The Rollover Protection System (Rops) - Toro 30344 Operator's Manual

1. Fill/check plug (one on each end of axle)
Checking the Bidirectional
Clutch Lubricant (Model 30345
only)
1. Position the machine on a level surface.
2. Rotate the clutch (Figure 29) so that the check plug
(shown in the 12 o'clock position) is positioned at 4
o'clock.
1. Bidirectional clutch
3. Remove the check plug.
The fluid level should be up to the hole in the clutch. If
the fluid level is low, add Mobil Fluid 424. The clutch
should be approximately 1/3 full.
4. Install the check plug.
Note: Do not use engine oil (i.e. 10W30) in the
bidirectional clutch. Anti-wear and extreme pressure
additives will cause undesirable clutch performance.
Note: Determine the left and right sides of the
machine from the normal operating position.
Figure 28
Figure 29
2. Check plug
Using the Rollover Protection
System (ROPS)
WARNING
To avoid injury or death from rollover: keep the
roll bar in the raised locked position and use the
seat belt.
Ensure that the rear part of the seat is secured with
the seat latch.
WARNING
There is no rollover protection when the roll bar is
in the down position.
• Lower the roll bar only when absolutely
necessary.
• Do not wear the seat belt when the roll bar is
in the down position.
• Drive slowly and carefully.
• Raise the roll bar as soon as clearance permits.
• Check carefully for overhead clearances (i.e.
branches, doorways, electrical wires) before
driving under any objects and do not contact
them.
• Lower roll bar slowly so damage to hood does
not occur.
Important: Lower the roll bar only when absolutely
necessary.
1. To lower the roll bar, remove the hairpin cotter pins
and remove the two pins (Figure 30).
1. Roll bar
2. Pin
2. Lower the roll bar to the down position.
3. Install the two pins and secure them with the hairpin
cotter pins (Figure 30).
31
Figure 30
3. Hairpin cotter pin