Installing The Steering Wheel; Installing The Hood Handle - Toro 30344 Operator's Manual

Note: Determine the left and right sides of the machine
from the normal operating position.
WARNING
The PTO universal shaft is attached to the machine
frame. Do not engage the PTO without first
removing the universal shaft or coupling it to a
suitable implement.
1

Installing the Steering Wheel

Parts needed for this procedure:
1
Steering wheel
1 Cover
Procedure
1. Remove the steering wheel from the shipping skid.
1. Steering wheel
2. Jam nut
3. Dust cover
Figure 3
4. Foam collar
5. Cover
6. Washer
2. Remove the jam nut and washer from the steering
shaft. Ensure that the foam collar and dust cover
remain on the steering shaft (Figure 3).
3. Slide the steering wheel and washer onto the steering
shaft (Figure 3).
4. Secure the steering wheel to the shaft with the jam nut.
Tighten the jam nut to 27-35 N-m (20-26 ft-lb).
5. Mount the cover to the steering wheel (Figure 3).
2

Installing the Hood Handle

Parts needed for this procedure:
1 Handle
2 Screws
Procedure
1. Remove and discard the 2 screws and nuts securing the
hood cable bracket and to the underside of the hood
(Figure 4).
1. Hood cable bracket
2. Mount the handle and the cable bracket to the hood
with 2 screws (Figure 5).
15
Figure 4