1. Positive (+)
WARNING
Connecting cables to the wrong post could
damage the electrical system and result in
personal injury.
Note: Ensure that the battery cables are routed away
from any sharp edges or moving parts.
8
Checking the Tire Pressure
No Parts Required
Procedure
The tires are over inflated for shipping. Therefore, release
some of the air to reduce the pressure. Correct air pressure in
front and rear tires is 138 kpa (20 psi).
Figure 11
2. Negative (-)
9
Installing the Lift Lock Lever
(For CE Only)
Parts needed for this procedure:
1
Lift lock lever
1
Flat washer
1
Spring washer
1
Spacer
1
Screw, 1/4 x 1 inch
1
Flange lock nut, 1/4 inch
Procedure
1. Carefully locate and puncture the control panel decal
material, in front of the lift switch, to expose the
mounting hole for the lift lock lever (Figure 12).
1. Mounting screw (4)
2. Control panel
2. Remove the (4) screws securing the control panel to
the machine (Figure 12).
3. Insert the lift lock lever, spacer, wave washer and
flat washer onto the 1/4 x 1 inch pan head screw
positioning as shown in Figure 13.
19
Figure 12
3. Mounting hole location