Engine Coolant - BOMBARDIER 2006 outlander max 400 Operator's Manual

To add oil, remove dipstick. Place a
funnel into the dipstick tube to avoid
spillage.
Add a small amount of recommended
oil and recheck oil level.
Repeat the above procedures until
oil level reaches the dipstick's upper
mark. Do not overfill.
Properly tighten dipstick.

Engine Coolant

Recommended Coolant
Always use ethylene-glycol antifreeze
containing corrosion inhibitors specifi-
cally for internal combustion aluminum
engines.
Cooling system
with Bombardier premixed coolant
(P/N 219 700 362) or with distilled
water and antifreeze solution (50%
distilled water, 50% antifreeze).
Coolant Level
WARNING
Check coolant level with engine
cold. Never add coolant in cool-
ing system when engine is hot.
Remove access panel.
_____________________
104
must be filled
V07A0BY
TYPICAL
With vehicle on a level surface, liquid
should be between MIN. and MAX.
level marks of coolant reservoir.
NOTE: When checking level at tem-
perature lower than 20°C (68°F), it
may be slightly lower than MIN. mark.
Add coolant up to MAX. mark if re-
quired. Use a funnel to avoid spillage.
Do not overfill.
Properly reinstall and tighten filler cap
and reinstall access panel.
If the coolant is added in the coolant
reservoir, check the level in the radia-
tor too. Add coolant if necessary.
WARNING
In order to avoid potential burning,
do not remove the radiator cap if
the engine is hot.
NOTE: A cooling system that fre-
quently requires coolant is the indica-
tion of leaks or engine problems. See
an authorized Bombardier ATV dealer.
Coolant Replacement
Refer to MAINTENANCE section.